Digi Embedded Yocto uses the hostapd package to manage the software access point (SoftAP) mode. When configured in this mode, client stations can connect to the device to communicate with other stations on the same Basic Service Set (BSS). The default configuration includes SoftAP mode by adding a wlan1 entry in /etc/network/interfaces. The hostapd daemon is started when the interface is brought up and stopped when it is brought down.

The wlan1 interface is disabled by default to improve the performance of the wlan0 interface in client infrastructure mode. You can bring it up manually with the following command:

~# ifup wlan1

You can also enable automatic bring-up by uncommenting the "auto wlan1" line in /etc/network/interfaces.

Digi Embedded Yocto provides a mechanism to support a different configuration file per Wi-Fi interface, allowing you to run multiple hostapd instances at the same time.

The /etc/init.d/hostapd init script automatically selects the appropriate configuration file /etc/hostapd_wlanX.conf (where X is the index of the wlan interface) for each interface.

The hostapd package provides a default configuration file /etc/hostapd.conf as a reference for the different available settings. This file is not used by Digi Embedded Yocto init scripts.

See http://w1.fi/cgit/hostap/tree/hostapd/hostapd.conf for a reference of all hostapd configuration options.

For example, a static wlan1 configuration entry configured in SoftAP mode would be:

/etc/network/interfaces
auto wlan1
iface wlan1 inet static
        address 192.168.46.30
        netmask 255.255.255.0
        post-up /etc/init.d/hostapd start
        pre-down /etc/init.d/hostapd stop

This configures wlan1 to run the /etc/init.d/hostapd init script. This script launches the hostapd daemon using the configuration file /etc/hostapd_wlan1.conf.

SoftAP configuration examples are described below.

802.11a/n/ac WPA2-PSK authentication with CCMP/AES encryption

This is the default configuration used by Digi Embedded Yocto.

/etc/hostapd_wlan1.conf
ctrl_interface=/var/run/hostapd
ctrl_interface_group=0
interface=wlan1
driver=nl80211

# WPA2-AES encryption
ssid=ap-wlan1-wpa2aes-a
auth_algs=1
wpa=2
wpa_key_mgmt=WPA-PSK
wpa_pairwise=CCMP
wpa_passphrase=password-wpa2aes

# IEEE 802.11ac channel 36
hw_mode=a
channel=36
ieee80211ac=1
ieee80211n=1

802.11b/g/n WPA2-PSK authentication with CCMP/AES encryption

/etc/hostapd_wlan1.conf
ctrl_interface=/var/run/hostapd
ctrl_interface_group=0
interface=wlan1
driver=nl80211

# WPA2-AES encryption
ssid=ap-wlan1-wpa2aes-n
auth_algs=1
wpa=2
wpa_key_mgmt=WPA-PSK
wpa_pairwise=CCMP
wpa_passphrase=password-wpa2aes

# IEEE 802.11n auto channel
hw_mode=g
channel=10
ieee80211n=1