Get started with your AnywhereUSB Plus
This section explains what comes with each AnywhereUSB Plus model, how to install the necessary software, and how to connect the hardware. After you have verified the AnywhereUSB Plus Hub components, the software installation, hardware connection, and initial connection process must be done individually for each computer.
Initial connection: Administrators only
Note The steps in this process must be done by an administrator. Once the setup is complete, any user can connect to a group, as described below in Create and configure groups.
Before you begin: Register your AnywhereUSB Plus
Step 1: Verify product components
Step 2: Determine AnywhereUSB Manager mode: Service or stand-alone
Step 3: Install the AnywhereUSB Manager
Step 4: Connect the power supply
Step 5: Connect to the Hub using an Ethernet LAN connection
Step 6: Connect the Hub to the network using Wi-Fi
Step 7: Verify initial connection
Step 8: Update the firmware on the AnywhereUSB Plus
Next steps after initial connection
Step 9: Create and connect to groups
PDF
