AnywhereUSB 24 Plus components

Verify that you have the following included, required, and optional equipment.

Equipment Description
Included equipment

AnywhereUSB 24-port device
Required additional equipment
  • STP Cat 7 Ethernet cable
  • IEC 60320 power cord
Optional equipment
  • An additional STP Cat 7 Ethernet cable
  • An additional IEC 60320 power cord
  • SFP+ modules
  • RS232 DB9 Console cable

 

Item Name Description
1 DB9 Console Used to access a console using the RS232 DTE interface.
2 USB port LEDs

The USB ports support 1.1, 2.0, and 3.1 USB devices.

The LED illuminates as follows, based on the speed of the USB device:

  • 1.1 (Full speed): Yellow
  • 2.0 (High speed): Green
  • 3.1 (Super speed): Blue
3 ETH 1/2

Connect a Cat 7 STP Ethernet cable. The second Ethernet cable is optional and used for redundancy.

Note Digi recommends that you use either the Ethernet cable or the SFP+ module. If both the Ethernet cable and the SFP+ module are connected, the SFP+ module will have priority.
4 SFP+ 1/2

Connect an SFP transceiver module for fiber connection, such as Finisar Network FTLX8574D3BCL SFP+. The second SFP+ module is optional and used for redundancy.
5 Fan1

The LED shows the status of Fan 1:

  • Solid green when the fan is running within normal range of use.
  • Solid red if the fan slows down or the Hub is overheating.
5 Fan2

The LED shows the status of Fan 2:

  • Solid green when the fan is running within normal range of use.
  • Solid red if the fan slows down or the Hub is overheating.
5 User

LED used for the Find Me feature. When this feature is activated, the LED blinks orange and then green. You can configure the Find Me feature in the web UI or by using the findme CL command.
5 PSU1 The LED is blue when the Hub is powered, and solid red if the Hub is not powered or the supply has failed.
5 PSU2 The LED is blue when the Hub is powered, and solid red if the Hub is not powered or the supply has failed.
5 Wi-Fi Service Reserved for future use.
5 WWAN1 Service Reserved for future use.
5 WWAN1 Signal Reserved for future use.
6 BT Reserved for future use.
7 Wi-Fi1 Reserved for future use.
8 Wi-Fi2 Reserved for future use.
9 Wi-Fi3 Reserved for future use.
10 Wi-Fi4 Reserved for future use.
11 WWAN2 Reserved for future use.
12 Core module Reserved for future use.
13 WWAN1 Reserved for future use.
14 Fan 1 Primary fan.
15 Fan 2 Secondary fan.
16 Power connector

Connect the power supply.
17 Power connector

Connect the second (optional) power supply. This is used for redundancy.
  Reset button

The reset button is on the side of the Hub.

Press this button to reset the AnywhereUSB® Plus Hub configuration to factory defaults. See Use the Reset button to restore factory defaults.