Configure the findme feature

You can use the findme feature to cause an LED on the Hub to blink, which can help you to identify a specific Hub.

• AnywhereUSB 2 Plus: When enabled, the power LED blinks green, then orange.
• AnywereUSB 8 Plus and AnywhereUSB 24 Plus: When enabled, the user LED blinks green, then orange.

Note You can also configure this feature using the findme CLI command.

1. Open the web UI.
2. Click Find Me LED in the Administration section. The Find Me LED page appears.

3. Click Activate. The "Find Me LED Status" message changes to blinking, and the message "The Find Me LED is blinking" appears at the top of the page. The appropriate LED on the Hub begins to blink.

4. When you have found the Hub, click Stop. The "Find Me LED Status" message changes to not blinking, and the message "The Find Me LED is stopped" appears at the top of the page.