AnywhereUSB 2 Plus components

Verify that you have the following included and required additional equipment.

Equipment Description
Included equipment

AnywhereUSB 2-port device.
Required additional equipment
  • STP Cat 7 Ethernet cable
  • Power supply kit (recommended): 1.8 amps per port. Digi PN 76000965.
  • Alternate power supply kits (may be used if USB port charging is not required):
  • AC Power Supply: US plug to 5 VDC. 2.5 mm locking barrel plug (3 A max). Digi PN 76000934.
  • AC Power Supply: EU plug to 5 VDC. 2.5mm locking barrel plug (3 A max). Digi PN 76000935.
  • AC Power Supply: Standard Temperature, Universal plugs (US, EU, UK, AU) to 5 VDC. 2.5mm locking barrel plug (3 A max). Digi PN 76002021.

 

Item Name Description
1 Ethernet connector Connect the STP Cat 7 Ethernet cable.
2 USB LEDs and ports

The USB port supports 1.1, 2.0, and 3.1 USB devices.

The LED illuminates as follows, based on the speed of the USB device:

  • 1.1 (Full speed): Yellow
  • 2.0 (High speed): Green
  • 3.1 (Super speed): Blue
3 Reset button

Use this button to reset the AnywhereUSB® Plus Hub configuration to factory defaults. See Use the Reset button to restore factory defaults.
4 (Power) LED

The LED is solid blue when the device is powered on.

This LED is also used for the Find Me feature. When this feature is activated, the LED blinks green and then orange. You can configure the Find Me feature in the web UI or by using the findme CLI command.
5 Power connector

Connect the power supply: 5 Volt DC center positive.

The Hub draws 5 Amp maximum when both USB ports are drawing 1.8 Amps each.