DO (Device Options)

This command applies to the XBee 3 Cellular LTE-M/NB-IoT.

Enables and disables special features on the XBee 3 Cellular LTE-M/NB-IoT.

Note For NB-IoT, TCP support is dependent on the network. Contact your network provider for details.

Bitfield

Bit	Description
0	Enable Remote Manager Controls whether Remote Manager is enabled. Digi recommends that Remote Manager remains enabled.
2	Enable USB Direct Set bit 2 to enable USB direct mode. After setting, use WR (Write) to write all values to flash and use FR (Force Reset) to reset the device. Note Setting P0 (DIO10/PWM0 Configuration) to 6 overrides setting DO bit 2.
3	Enable PSM To enable PSM, set DO (Device Options) bit 3. See Power Saving Mode (PSM).
4	Enable the Low Voltage Shutdown feature Set bit 4 to enable the Low Voltage Shutdown feature. See Low voltage shutdown.
5	Enable eDRX Set bit 5 to request the eDRX feature from the network. The requested cycle length is defined by the DX command, and the network-provided cycle length can be read using D? command, once the device is registered on the network. When connected to the network, the AI command is set to 0.

Note We strongly recommend that you clear bit 0 (Enable Remote Manager) if you set bit 3. If not, the connection that the device retains with Remote Manager causes the cellular component to spend very little time in low power, negating the value of selecting that feature.

Bit	Description
0	Enable Remote Manager support Controls whether Remote Manager is enabled. Digi recommends that Remote Manager remains enabled.
1-7	Reserved for future use

Default

1 (Bit 0 enabled)