How to enable and configure routing using VLAN sub-interfaces with bonding

This article will explain how to enable and configure routing using VLAN sub-interfaces with bonding interfaces.

1.  At first step we need set up Ethernet bonding interface:    
   Configuration > Network > Ethernet bonding

     2. Next, we must add VLANs with the appropriate VLANs ID.
 

    3. Then, we can create Layer 3 interfaces for each VLAN to route traffic to the appropriate   VLAN.

Please note, Round-robin mode does not support IEEE 802.3ad Dynamic link aggregation protocol (LACP) that Utilizes all slaves in the active aggregator according to the 802.3ad specification.

Opposite ports on the Ethernet switch must be configured in a static port channel.