Review EX15 default settings

You can review the default settings for your EX15 device by using the local WebUI or Digi Remote Manager:

Local WebUI

  1. Log into the EX15 WebUI as a user with Admin access. See Using the local web interface for details.
  2. On the menu, click System > Device Configuration.

Digi Remote Manager

  1. If you have not already done so, connect to your Digi Remote Manager account.
  2. From the menu, click Devices to display a list of your devices.
  3. Locate your device as described in Use Digi Remote Manager to view and manage your device.
  4. Click the Device ID.
  5. Click Settings.
  6. Click to expand Config.

The following tables list important factory default settings for the EX15.

Default interface configuration

Interface type Preconfigured interfaces Devices Default configuration
Wide Area Network (WAN)
  • WAN
  • Ethernet: 2/WAN
  • Firewall zone: External
  • WAN priority: Metric=1
  • IP Address: DHCP client
  • Digi SureLinkTM enabled for IPv4
Wireless Wide Area Network (WWAN)
  • Modem
  • Modem
  • Firewall zone: External
  • WAN priority: Metric=3
  • SIM failover after 5 attempts
  • SureLink enabled for IPv4
Local Area Network (LAN)
  • LAN
  • Ethernet: 1/PoE
  • Passthrough mode
  • Firewall zone: Internal
  • LAN priority: Metric=5
  • Surelink disabled
 
  • Loopback
  • Ethernet: Loopback
  • Firewall zone: Loopback
  • IP address: 127.0.0.1/8
 
  • Setup IP
  • Bridge: LAN
  • Firewall zone: Setup
  • IP address 192.168.210.1/24
 
  • Setup Link-local IP
  • Bridge: LAN
  • Firewall zone: Setup
  • IP address 169.254.100.100/16
Wi-Fi (available with EX15W models only)
  • Wi-Fi access point: Digi AP
  • Wi-Fi radio
  • Enabled

    Note While the access point is enabled by default, see Use the default Wi-Fi access point for procedures required to use the access point.

  • SSID: Digi-EX15W-serial_number
  • Encryption: WPA2 Personal (PSK)
  • Pre-shared key: The unique password printed on the bottom label of the device.