Review 6310-DX default settings

Note Devices manufactured with firmware version 20.2.x or greater are configured by default to use the Digi Remote Manager for cloud-based central device management. For information about configuring the device to use aView for central management instead, see Configure the device to use aView for central management.

You can review the default settings for your 6310-DX device by using the local WebUI or Digi Remote Manager:

Local WebUI

  1. Log into the 6310-DX WebUI as a user with Admin access. See Using the web interface for details.
  2. On the menu, click System > Device Configuration.

Digi Remote Manager

  1. If you have not already done so, connect to your Digi Remote Manager account.
  2. Click Device Management to display a list of your devices.
  3. Locate and select your device as described in Use Digi Remote Manager to view and manage your device.
  4. Click Configure.

The following tables list important factory default settings for the 6310-DX.

Default interface configuration

Interface type Preconfigured interfaces Devices Default configuration
Wide Area Network (WAN)
  • WAN
  • Ethernet: 2/WAN
  • Firewall zone: External
  • WAN priority: Metric=1
  • IP Address: DHCP client
  • Digi SureLinkTM enabled for IPv4
Wireless Wide Area Network (WWAN)
  • Modem
  • Modem
  • Firewall zone: External
  • WAN priority: Metric=3
  • SIM failover after 5 attempts
  • SureLink enabled for IPv4
Local Area Network (LAN)
  • LAN
  • Ethernet: 1/PoE
  • Passthrough mode
  • Firewall zone: Internal
  • LAN priority: Metric=5
  • Surelink disabled
 
  • Loopback
  • Ethernet: Loopback
  • Firewall zone: Loopback
  • IP address: 127.0.0.1/8
 
  • Default IP
  • Bridge: LAN1
  • Firewall zone: Setup
  • IP address 192.168.210.1/24
 
  • Default Link-local IP
  • Bridge: LAN1
  • Firewall zone: Setup
  • IP address 169.254.100.100/16