Reboot the Hub

You can reboot the Hub if needed. For example, changes to some Hub settings require saving the changes and rebooting the Hub for the changes to take effect on the Hub.

Note If the Set Time option is selected in the Time Configuration page, and the Hub is rebooted, the Set Time option is de-selected and the time reverts to the last time stamp that was written to the Hub log file. If you want to more accurately set the time, you should either configure time server synchronization or manually re-set the time.

1. Open the web UI.
2. Select Reboot from the Administration section. The System Reboot Confirmation page appears.
3. Click Reboot.
4. Wait approximately 15 seconds for the reboot to complete. When the reboot is complete, all the LEDs turn on and then turn off, leaving the power LEDs on. For the AnywhereUSB 24 Plus model, one or both of the power LEDs will be on.