Connect the cellular hardware

  1. Install a SIM card. See Set up and configure a cellular device for instructions.

  2. Optional: If you are using an Ethernet connection in addition to the cellular, connect one end of the Ethernet cable to your gateway and the other to a live Ethernet jack.

  3. Connect the XBee antenna to the device.
  4. Connect the cellular antenna(s) to the device. If your device has two cellular antenna locations, you must connect an antenna to each location.

  5. Connect the power supply.

  6. Startup Sequence - After power is applied:

    a. Power LED is dark when the power is off The Power LED turns solid blue.
    b. The XBee LED turns blinking green when XBee Industrial Gateway creates a ZigBee network.
    c. Network LED The Network LED blinks yellow and green and then turns solid green when XBee Industrial Gateway connects to Remote Manager.
    d. For the Cellular model, the Signal Strength LED turns either yellow or green, depending on the cellular signal strength.