Configure the internal GNSS module

The internal GNSS module is enabled by default. You can disable it, or you can enable it if it has been disabled.

Note In order for the internal GNSS module to be able to provide location information, you must connect an antenna to the GNSS antenna connector.


  Web

  1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access rights.
  2. Access the device configuration:

    1. Locate your device as described in Use Digi Remote Manager to view and manage your device.
    2. Click the Device ID.
    3. Click Settings.
    4. Click to expand Config.

    1. On the menu, click System. Under Configuration, click Device Configuration.

      The Configuration window is displayed.

  3. Click Services > Location > Location sources > gnss.
  4. (Optional) Type a Label for the GNSS location source.
  5. For Type of location source, leave the selection at GNSS.
  6. Click Enable the location source to disable the internal GNSS module, or to enable it if it has been disabled.

    7. Alternatively, you can also delete the gnss location source:

    1. Click the menu icon (...) next to the gnss location source
    2. Click Delete.

  7. Click Apply to save the configuration and apply the change.
  1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX64-PR local command line as a user with full Admin access rights.

    Depending on your device configuration, you may be presented with an Access selection menu. Type admin to access the Admin CLI.

  2. At the command line, type config to enter configuration mode:
    > config
(config)>
  3. Enable or disable the GNSS module:
    1. Use the show command to determine the index number of the GNSS location source:
      (config)> show service location source
0
	enable true
	no label
	type usb
1
	enable true
	no label
	type gnss
(config)>
    2. Use the index number to enable or disable the module:
      • To enable the module:
        (config)> service location source 1 enable true
(config)>
      • To disable the module:
        (config)> service location source 1 enable false
(config)>

      Alternatively, you can use the index number to delete the DNSS location source:

      (config)> del service location 1
(config)>

  4. (Optional) Set a label for this location source:

    (config)> service location source 1 label "label"
(config)>

  5. Save the configuration and apply the change
    (config)> save
Configuration saved.
>
  6. Type exit to exit the Admin CLI.

    Depending on your device configuration, you may be presented with an Access selection menu. Type quit to disconnect from the device.