Using the local web interface

• Summarizes network statistics: the total number of bytes sent and received over all configured bridges and Ethernet devices.

• Displays the status of the network interfaces configured on the device.

• Provides information about the signal strength and technology of the cellular modem(s).

Displays the device connection status for Digi Remote Manager, the amount of time the connection has been up, and the Digi Remote Manager device ID.

See Using Digi Remote Manager.

The links in this section enable you to do the following:

• Launch Digi Remote Manager: Click Go To Digi Remote Manager to open the Digi Remote Manager login page.

• Add a device to Remote Manager: Click Register device in new account to add a device to Remote Manager using your Remote Manager login credentials.

Displays the IX20 device's status, statistics, and identifying information.

Displays information about the serial ports on the IX20. Each serial port is identified by port name or number, followed by the serial port mode configured for the port.

The icons next to the port name or number shows the serial port status:

• Empty circle: Port is not connected.

• Green circle: Active connection on the port.

• Red X: No signal, which is an error state where the port is not available.

• Down arrow: One of the control signals is not active. This icon may display For for ports configured in Remote Access serial port mode and that have a signal monitor enabled (CTS or DCD) in the Monitoring Settings section.

You can click the icons at the top of the section to access other pages:

• Blue "i": Click to access the Serial Status page.

• Blue wrench: Click to access the Serial Configuration page.