Step 2: Set up the hardware
Follow these steps to set up your hardware:
Note Connections vary slightly based on SBC version. See Identify the ConnectCore 6 SBC version.
- Connect the serial adapter cable to the console port [CONS]. Then connect a serial cable from the adapter to the development computer.
- Connect the Ethernet cable (not included) to the Ethernet port.
- Connect the antenna to the UFL connector.
- Connect an HDMI cable (not included) to the HDMI connector and then to an HDMI-compatible display.
- Connect a USB mouse to the USB connector.
- Add the appropriate plug and connect the power supply.
- Ensure the BOOT micro-switches are both in the down position.
- Connect the serial adapter cable to the console port [CONS]. Then connect a serial cable from the adapter to the development computer.
- (Optional) Connect the Ethernet cable (not included) to the Ethernet port.
- Connect the antenna to the UFL connector.
- Connect an HDMI cable (not included) to the HDMI connector and then to an HDMI-compatible display.
- Connect a USB mouse to the USB connector.
- Add the appropriate plug and connect the power supply.
- Ensure the BOOT jumpers are both open.