DO (Miscellaneous Device Options)
This command applies to the XBee 3 Zigbee RF Module.
A bitfield that contains advanced device options that do not have dedicated AT commands.
Leave unused bits clear so future device options are not inadvertently enabled during a firmware update.
Bit field:
Unused bits must be set to 0. These bits may be logically OR'ed together:
Bit | Description |
---|---|
0 | Reserved. |
1 | Reserved. |
2 | Reserved. |
3 | Reserved. |
4 | Disable Tx packet extended timeout. |
5 | Disable ACK for end device I/O sampling. |
6 |
Enable High-RAM concentrator. Set this bit to 0 for Low-RAM concentrator, where Route Record Indicator - 0xA1 frames will be emitted for external storage and use in subsequent Create Source Route - 0x21 frames. This option will only take effect when AR < 0xFF or when enabling source routing. |
7 |
When the Network Watchdog triggers, search for a coordinator on a new network to join. The Network Watchdog must be enabled for this to take effect—NW (Network Watchdog Timeout) > 0. With this bit set, the device will remain on the current network until a valid coordinator is found. If the coordinator is found on a different network, the device will leave the current network and join the new network. |
Parameter range
0 - 0xFF
Default
0x40