ConnectPort TS 16 and ConnectPort TS 16-MEI

Item	Description
Serial ports	You can configure the device to allow network administrators to access serial ports from the LAN. See Serial ports configuration.
Ethernet port	Configure the Ethernet port.
USB ports	Use the USB port to connect a flash drive to the device. You can use the flashdrv command to view information about the flash drive.
Power Connector	Connect a power source to the device.
Reset button	Reset the factory settings on a Digi Connect and ConnectPort TS Family product using the Reset button.

LED/button	Color and Light Pattern	Description
Power LED	Solid Green	Power on.
Diag LED	Amber	Blinks during product initialization and factory reset, using the light patterns below. This LED should never blink during normal operation. If it blinks constantly, contact Digi Technical Support.
	1-1-1 blinking amber	Initializing firmware.
	1-5-1 blinking amber	Device configuration has been restored to its factory defaults.
	Other blinking amber	Contact Digi Technical Support.
	Solid amber	Device is powered on and ready for operation.
C1 and C2 LEDs	Green	You can use these LEDs with custom applications running on the unit.
Reset button	N/A	Performs equivalent of a power-cycle.
Serial TX	Yellow	Serial port is transmitting data.
Serial RX	Green	Serial port is receiving data.
Ethernet Link LED	Solid green	Ethernet link is up. Will light solid green when an active LAN connection is plugged into the Ethernet port.
Ethernet Activity LED	Blinking yellow	Blinks when active traffic is on the LAN connection.