AC (Apply Changes)

This command applies to the XBee 3 Cellular LTE-M/NB-IoT.

Immediately applies new settings without exiting Command mode.

Applying changes means that the device re-initializes based on changes made to its parameter values. Once changes are applied, the device immediately operates according to the new parameter values.

This behavior is in contrast to issuing the WR (Write) command. The WR command saves parameter values to non-volatile memory, but the device still operates according to previously saved values until the device is rebooted or you issue the CN (Exit AT Command Mode) or AC commands.

Parameter range

N/A

Default

N/A