NR (Network Reset)

This command applies to the XBee/XBee-PRO Zigbee RF Module.

Resets network layer parameters on one or more modules within a PAN. Responds immediately with an OK then causes a network restart. The device loses all network configuration and routing information.

If NR = 0: Resets network layer parameters on the node issuing the command.

If NR = 1: Sends broadcast transmission to reset network layer parameters on all nodes in the PAN.

Note NR and NR0 both perform the same function and may be used interchangeably.

Parameter range

0 - 1

Default

N/A