Connect the XBee Gateway hardware
- Connect the power supply as shown in the following figure.
- Optional: If you are using an Ethernet network connection in addition to Wi-Fi, connect one end of the Ethernet cable to your gateway and the other to a live Ethernet jack.
- The start up sequence that occurs after power is applied is as follows:
a. |
![]() |
The Power LED turns solid green. | |
b. |
![]() |
The XBee LED turns blinking green when the XBee Gateway creates a Zigbee network. | |
c. | ![]() |
The Network LED gradually turns solid green when the XBee Gateway connects to Remote Manager. |