Closing the Connect Sensor+

The Connect Sensor+ enclosure with a gasket may require some force to close. This is intended as part of the design to ensure a robust seal in damp or dusty environments.

All Connect Sensor+ products are shipped to you closed. You will need to open the device to install the battery and to wire third-party sensors to the Connect Sensor+ I/O interface.

Note Using gaskets, seals, glands or plugs other than those supplied by Digi may void certifications and regulatory approvals.

If you have problems closing the enclosure after either of these operations, please follow these instructions:

1. Ensure the gasket is fully seated in the groove on the enclosure.

2. Place the device on a flat, stable surface.

3. Apply pressure to the top of the Connect Sensor+ and pull the front door clip closed with your finger.