Connect the cellular hardware

Connect hardware example for XBee Gateway Cellular

  1. Install a SIM card. See Set up and configure GSM-based devices for instructions.

  2. Optional: If you are using an Ethernet connection in addition to the cellular, connect one end of the Ethernet cable to your gateway and the other to a live Ethernet jack.

  3. Connect the power supply.

  4. Startup Sequence - After power is applied:

    a. Power LED The Power LED turns solid green.
    b. XBee LED The XBee LED turns blinking green when XBee Gateway creates a ZigBee network.
    c. Network LED The Network LED gradually turns solid green when XBee Gateway connects to Remote Manager.
    d. Signal strength LED For the Cellular model, the Signal Strength LED turns either yellow or green, depending on the cellular signal strength.