Open and close the device enclosure

You will need a screwdriver to open and close the device enclosure.

Open the enclosure

1. Remove the six screws on the lid.
2. Open the lid. The lid is hinged to the base on the power cord side.

 

Close the enclosure

1. Close the lid. The lid is hinged to the base on the power cord side.
2.  Replace the screws that were removed when you opened the lid.

   Note Digi recommends that you use 2.5 inches per pound of torque when tightening the screws. You should tighten the screws in a criss-cross pattern to ensure that the cover is not bent or skewed during this process.