You are viewing an article about an obsolete product. Information on this page is provided as-is and not supported.

The "set auth" ability on the PortServer II doesn't work properly

The "set auth" command does not properly control access to the ports by IP addresses in PortServer II firmware versions 3.1.5, 3.1.9, 3.1.10, and 3.1.11.

To get the proper access control via IP address using the "set auth" command in the PortServer II, you must use firmware version 3.1.4.

Last updated: Jan 10, 2024

Filed Under

Network

Recently Viewed

No recently viewed articles

Did you find this article helpful?