You are viewing an article about an obsolete product. Information on this page is provided as-is and not supported.

How to Configure Serial port for RS485 on a Digi Transport

If the Digi TransPort has RS485 option in its hardware, you can change mode of the serial port by navigating to Configuration - Network > Interfaces > Serial > Serial Port 0 > Advanced, locate the option titled Async Mode and change the parameter to RS485, as shown below:

User-added image

After this is done, make sure to click the Apply & Save Change to Profile 0 button to set the changes on the port.  Note: This is not the standard Apply and Save buttons

Last updated: Jan 05, 2024

Filed Under

Cellular/Transport

Recently Viewed

No recently viewed articles

Did you find this article helpful?