Home  >  Support  >  Support Forum  >  Entering API mode
Notice! We've recently migrated to using a new forum, we hope you enjoy it. If you are an existing member and this is your first time visiting our new forum, please reset your password to be able to sign in.

Entering API mode

0 votes
Several years ago I had used the xbee/xbee-pro modules heavily and it was more-or-less smooth sailing.

I recently purchased two XBP09-XSC modules (in the development kit) and am trying to have them communication with each other. I can make transparent mode work ok but am having a hard time with API mode and am wondering if the module is even in API mode.

In the old code, I could send:

ATAP 1

to enter api mode but when I type this in the xctu terminal I get an error, which suggests my code is not entering API mode.

I have seen nothing about API mode in the XBee‐PRO® XSC OEM RF Module manual. How do I get this module to enter API mode?

Thanks --
asked Dec 8, 2011 in Multipoint Proprietary by yp66 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Maybe reflashing the firmware will help.
Use below steps to reflash the firmware on the module.
- Select correct Modem, Function set and Version
- Click "Show defaults"
- Check "Always Update Firmware"
- Click "Write"
Now go to Terminal tab and try the command
answered Sep 23, 2013 by 16ksa23 Veteran of the Digi Community (376 points)
Contact a Digi expert and get started today! CONTACT US
...