Home  >  Support  >  Support Forum  >  Point to Multipoint configuration problems

Point to Multipoint configuration problems

0 votes
Hi there,

Probably a super simply question - apologies if it is.

I'm trying to set up a point to multipoint network.

I have used this document
"Digi - getting started guide" and have configured my xbees as described on page 16.

(The base DH = 0, DL = 0xFFFF and MY = 0
The remotes DH = 0, DL = 0 and MY = the number assigned)

Some modules are talking some are not. I've checked the Baudrate on them all too to make sure that's the same.

I am mixing units (all series 1)
- 3 are new (1mw u.fl connection)
- 2 are ones I bought in 2010 with a chip antenna.

Currently the Base is one of the new units and works.
The 2 old remote units work.
The 2 new remote units don't work.

The units are hooked up to an arduino sending simple serial data (using an xbee explorer)

For the non-working units the indicators show power is there but no other activity.

Any idea what I could be missing?
What other settings could be causing problems?

(I haven't changed any other settings on the boards - the rest are all default)

Thanks for your time!
asked Aug 12 in RF Solutions and XBee by claireandrewz New to the Community (0 points)
recategorized Aug 13 by claireandrewz

Please log in or register to answer this question.

1 Answer

0 votes
Try connecting an antenna to the U.FL connector.
answered Aug 18 by mvut Veteran of the Digi Community (1,593 points)
Contact a Digi expert and get started today! CONTACT US
...