Home  >  Support  >  Support Forum  >  Sir/Madam Please guide me to interface two RCM4000 modules,so that I can send data from one RCM4000 to another.
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Sir/Madam Please guide me to interface two RCM4000 modules,so that I can send data from one RCM4000 to another.

0 votes
Is it ok to activate one RCM4000 as a master and the other RCM4000 as the slave? If so,please guide me how to provide the commands to program both the master and slave RCM modules.I am confused about the code.I hope to receive a perfect solution to my problem.I have confusion with the registers ,so kindly guide me about which all registers to be used for both the slave and for the master.
asked Jul 1 in Rabbit Software by AISWARYA RAJ New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Take a look at samples\slaveport\*.c
answered Jul 7 by trooper2 Veteran of the Digi Community (564 points)
Contact a Digi expert and get started today! CONTACT US
...