Home  >  Support  >  Support Forum  >  HDLC Link management ... (SABM & UA) ???
Notice! We've recently migrated to using a new forum, we hope you enjoy it. If you are an existing member and this is your first time visiting our new forum, please reset your password to be able to sign in.
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

HDLC Link management ... (SABM & UA) ???

0 votes
i use RCM6700 for HDLC. (Serial F)

between two rabbit module, hdlc working very well.

but .between rabbit and another hdlc device,

occur problem.

the problem occur in the following flow.

1. another hdlc device send SABM message to rabbit.

SABM (Set Asynchronous Balanced Mode)

2. rabbit send UA message to another hdlc device.

UA (Unnumbered Acknowledgement)

as above... after sending the UA message ..

rabbit do not receive any data.

so.. check rx_data pin using oscilloscope.

rx_data signal moves.

What is the problem ???

I would not know how to debug. ㅜㅜ
asked Jun 20 in Rabbit by hcyoo New to the Community (0 points)

Please log in or register to answer this question.

Your M2M Expert™for Businessfor Developers
Newsletter SignupYouTubeGoogle+FacebookCopyright © 1996-2013 Digi International Inc. All rights reserved. Legal
...