Home  >  Support  >  Support Forum  >  How to configure XBee using new XCTU software

How to configure XBee using new XCTU software

0 votes
Hi,
I'm referring the book "Building Wireless Sensor Networks" by Robert Faludi, to learn about XBees. In the book, the author is using some old version of the XCTU software and I can't figure out how to configure the XBees as described in the book. Specifically, setting the class of radio modem and configuring the coordinator radio and router, in AT command mode.

Can someone please help on how to do this in the newer version?
Screenshots would be great.
asked Jun 17 in XBee Programmable Development by vreg New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You change function sets or firmware versions in this version(6.x) by going to the tools menu and selecting the XBe recovery. Then follow the on screen directions.
answered Jun 19 by mvut Veteran of the Digi Community (1,973 points)
Contact a Digi expert and get started today! CONTACT US
...