Home  >  Support  >  Support Forum  >  Communication by mcu with xbee ZB module

Communication by mcu with xbee ZB module

0 votes
How do you start communicating with the xbee ZB module via microcontroller (uart)? I mean what is the data to be sent to the module before starting to send the data to be transmitted?
asked Jun 11 in RF Solutions and XBee by Kimaya New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Nope, just think of the radio as nothing more than a cable. Simply send your data as you would if you had physically ran a cable between the devices.
answered Jun 11 by mvut Veteran of the Digi Community (1,582 points)
What is transparent and API serial interface?
Thanks a lot! But then what is transparent and API serial interface for? Are those interfaces just to configure the module as either co-ordinator, router or end device and for other parameters like baud rate etc? Also if my end device would be connected to mcu in the final design, then do i have to configure it via usb as end device (i mean before using it in my design)?
Contact a Digi expert and get started today! CONTACT US
...