Home  >  Support  >  Support Forum  >  Problem with S1 node XB24-DM VER. 8067
Notice! We've recently migrated to using a new forum, we hope you enjoy it. If you are an existing member and this is your first time visiting our new forum, please reset your password to be able to sign in.

Problem with S1 node XB24-DM VER. 8067

0 votes
Hello,
I have in network two nodes: A transmitter, B receiver.
Node A sends every 1s a message with an acknowledgement
to node B.
After sending about 200 messages node A hangs, stops responding to uart and need to reset it. Node B still works.

When I changed node A to S1 PRO XBP24-DM module VER. 8062 all is ok, it worked all night.

Do you have any ideas what is going on?

Thanks.
asked May 30 in DigiMesh Proprietary Mesh Networking by zolax New to the Community (2 points)
edited May 30 by zolax

Please log in or register to answer this question.

2 Answers

0 votes
What firmware version were you using before?
answered May 30 by mvut Veteran of the Digi Community (1,555 points)
XB24-DM VER. 8067
One more thing: when we flashed this S1 with older soft (the same which S1 pro already had - 8062) all is also stable.
Thanks.
What happens when you flash them with the Point to point 802.15.4 code on them? Why are you using Mesh for a point to point connection?  Are you using hardware flow control at all?
0 votes
Hi,
actually we test only two nodes but final project has about 1000-2000 nodes in one network. Yes we have hardware flow control.
Thanks.
answered Jun 2 by zolax New to the Community (2 points)
Do you see this issue when you use Unicast addressing over the default broadcast?
Contact a Digi expert and get started today! CONTACT US
...