Home  >  Support  >  Support Forum  >  No UART output in a XBee pro 900hp as ROUTER device

No UART output in a XBee pro 900hp as ROUTER device

0 votes
I have configured a network with xbee pro 900hp modules.

One of them is the coordinator (API=1); others are Routers. (API=1)
When I send a Transmission Request (0x10) from Coordinator to any router device, I can see the response from the router (0x8B) and successful. (no errors). The problem is: there isn't UART output.

When I send a Transmission request from the Router to Coordinator, all is OK, and I see the Cordinator response frame as UART output .

Thanks.
asked May 27 in DigiMesh Proprietary Mesh Networking by vasama New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

0 votes
 
Best answer
Can you add your API frames you are sending to this post?
answered May 28 by mvut Veteran of the Digi Community (2,143 points)
selected May 28 by vasama
Yes, of course.

API Frame sent from Router to Coordinator:

7E 0F 10 01 (00 13  A2   00 40  B2  7F FC)  FF  FE  00  00 (1F) + Checksum.

- API Frame sent from  Coordinator to Router:

7E 0F 10 01 (00 13  A2   00 40  xx  xx xx)  FF  FE  00  00 (55) + Checksum.

(I'm sorry, at this moment I don't have the router lower 3 byte (xx xx xx) MAC address, but remember the Router sent to coordinator a successful API frame (I can see it on Coordinator X-CTU program).

Is there any problem with Destination Address, because when the coordinator sent the response to the router (API frame "Transmit Status"), there isn't explicit destination address?

Thanks again
There is one thing you are missing in your TX request packet which is the Data Payload.  Try adding something in for the data packet and then see what you get.
Contact a Digi expert and get started today! CONTACT US
...