Home  >  Support  >  Support Forum  >  Xbee modules dont work in release mode but do work in debug mode
Notice! We've recently migrated to using a new forum, we hope you enjoy it. If you are an existing member and this is your first time visiting our new forum, please reset your password to be able to sign in.

Xbee modules dont work in release mode but do work in debug mode

0 votes
When in debug mode and I set the debugger to run mode the two modules talk to each other - But when I change to release mode
the modues do not receive the data even though I have tested with my oscilloscope that that data is being sent from the pic microcontroller to the Din pin of the Xbee.
in both release and debug mode.
I did upgrade firmware in Xbee using Xctu as these modules are quite old- could that be the problem?

Regards

Peter
asked May 14 in IEEE 802.15.4 by barmed New to the Community (1 point)

Please log in or register to answer this question.

2 Answers

0 votes
Peter what is the exact XBee module part number and firmware version you are working with?
answered May 15 by mvut Veteran of the Digi Community (1,429 points)
0 votes
Thanks for your reply.

both are Rev 2 PN: 30009652-01
I'm not sure about the '6' and '5' as they are partially covered by the antenna. There is date - 2009-04-01
Current firmware version is 1084

If I reset the modules using AT command (ATRE) could that fix the problem?

Regards

Peter Barrett MIEAust
answered May 16 by barmed New to the Community (1 point)
These are not programmable modules. You should not be trying to upload any code with a Debugger to them.
Peter I don't think that is a Programmable module. The part number I am looking for should be something like XB24-AWI-001 and will be on the white label on the bottom of the module.
Contact a Digi expert and get started today! CONTACT US
...