Home  >  Support  >  Support Forum  >  Is there any need to connect the clock pins together of the RCMs for external interfacing of two RCM4000 modules?
Notice! We've recently migrated to using a new forum, we hope you enjoy it. If you are an existing member and this is your first time visiting our new forum, please reset your password to be able to sign in.
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Is there any need to connect the clock pins together of the RCMs for external interfacing of two RCM4000 modules?

0 votes
asked May 7 in Rabbit Software by AISWARYA RAJ New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Hello,It seems like all slave port operations are based on the processor clock.Yo do not need to connect any extra clock pin. Did you go through the below document?

http://ftp1.digi.com/support/documentation/019-0152_N.pdf
answered May 8 by cpigilam Veteran of the Digi Community (522 points)
Contact a Digi expert and get started today! CONTACT US
...