Home  >  Support  >  Support Forum  >  Please provide a sample program for demonstrating external interfacing of RCM4000 ?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Please provide a sample program for demonstrating external interfacing of RCM4000 ?

0 votes
asked Apr 28 in Rabbit Software by AISWARYA RAJ New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Hello, What exactly you want to interface with the RCM4000 and how you want to interface?

There is a sample applications MASTER_DEMO.C under
C:\DCRABBIT_10.72\Samples\SlavePort
Please check,It may useful.
answered Apr 28 by cpigilam Veteran of the Digi Community (499 points)
sir can u please provide your email-id ,so that I can enquire more about this topic ?
Sir ,I want to interface two RCM4000 modules each other.I am having lot of confusion regarding the parallel port interfacing ,data ,address lines,etc. as I haven't yet interfaced any devices.
Sir ,I want to interface two RCM4000 modules each other.
Dear Aiswarya,

At digi website there is one more document regarding, How to interface two devices as a master and slave. I hope this helps you a lot.
Please go through the below technical note.

http://ftp1.digi.com/support/documentation/0220132_a.pdf

Thanks.




http://ftp1.digi.com/support/documentation/0220132_a.pdf
Hello Aiswarya,
One more document that will useful for you.This is Rabbit 4000 processor user's manual, In this doc explained that the communication between Master and slave. pls check the section 18.Slave port,I hope  it might helpful.
http://ftp1.digi.com/support/documentation/019-0152_N.pdf

Thanks.
Sir,so for interfacing two RCM4000 modules together,should we implement the master-slave technique?
Contact a Digi expert and get started today! CONTACT US
...