Home  >  Support  >  Support Forum  >  Reseting Xbee

Reseting Xbee

0 votes
I am using xbee XB24-B, I tried to write "ZNET 2.5 router/end device analog io" function set using XCTU but now xctu is unable to detect the xbee.
Earlier I was using it in "Zigbee Router/End Device API" function set and it was working fine but now I am unable to rewrite "Zigbee Router/End Device API" function set in Xbee. Please help to solve this problem.
Thanks in advance.
asked Apr 8, 2014 in IEEE 802.15.4 by amit0016 New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Best answer
Reflash the firmware
answered Apr 9, 2014 by 16ksa23 Veteran of the Digi Community (410 points)
selected Apr 11, 2014 by amit0016
Thanks for your help.
I am also facing a problem related to xbee and requires your help. Actually I am making a project  "Home automation using xbee".
In this project I want to use pir sensor,fire sensor and receive its output through xbee  at controller(pic 16877A) side to the Xbee at user end and controlling the ac devices accordingly from computer. But my main problem is that I am not able to configure my xbee for both receiving and transmitting simultaneously. One of my xbee is acting like receiver and other is acting like transmitter at a time. Since I require my xbee to obtain signals from sensors at controller side to the pc and send commands from my pc to the controller and control devices and therefore seeking your help to configure xbee for transmission and reception simultaneously.

 Do I need to use 4 xbee i.e 2 at controller side for transmitting and receiving respectively and two at pc end for receiving and transmitting or it is possible using 2 xbee only i.e 1 at controller side and other one at pc side for transmitting and receiving respectively.
My xbee model is:- XB24-B
Contact a Digi expert and get started today! CONTACT US