Home  >  Support  >  Support Forum  >  how I can r the configration of xstick to discover sensor ?

how I can r the configration of xstick to discover sensor ?

0 votes
hello , I have xstick zb 2 coordinator , I were configure sensor channel to digital out low (d0, d1, d3, d4) after that my xstick can not discover the sensor how can I discover the sensor again ..how I can reset the sensor or change the configration of xstick to discover sensor ?
asked Mar 31 in RF Solutions and XBee by ayat New to the Community (0 points)
edited Mar 29 by ayat

Please log in or register to answer this question.

1 Answer

0 votes
You are going to need to issue a remote ATRE command with the WR after. Sensors have to be configured for Input on the lines otherwise you are driving two devices that both want to output or drive the line.
answered May 6 by mvut Veteran of the Digi Community (1,625 points)
Contact a Digi expert and get started today! CONTACT US
...