Home  >  Support  >  Support Forum  >  Configure Xbee in API Mode (Program Modem to AT Mode)
Notice! We've recently migrated to using a new forum, we hope you enjoy it. If you are an existing member and this is your first time visiting our new forum, please reset your password to be able to sign in.

Configure Xbee in API Mode (Program Modem to AT Mode)

0 votes
Hello All,

I have configured Xbee in API Mode.

PC : WIN XP SP3
XCTU : 5.3.8.6
Baud rate : 9600
COM Port : Serial COM1
"Test/Query" : OK

I am not able to Configure it with XCTU
Read/Write Modem : Failed to enter command mode
Error : Action Required Dialogue doesn't disappear.

I want to change modem configuration & Program it with AT Mode.

Can you please help ?

Regards,
Vijay
asked Mar 18 in XBee Programmable Development by vijay.amrutkar New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
Hello Again,

I have checked again with another Xbee Base Module.
Test/Query is ok.

XCTU shows COORDINATOR AT Version - 1020 & ROUTER AT Version - 1220 in Modem Config

Reading Module parameters gives OK result in XCTU.
But, doesn't show Modem Type,Function Set & Version.

Writing any value gives error : Getting modem type....OK
Programming modem...Lost communication with modem
Write Parameters...Failed.

Also, Terminal shows - Echo for any typed char.

Interesting info is that :
For 1st Xbee => LED Blinks 2 times per second (I think its Router)
For 2nd Xbee => LED Blinks 1 time per second (I think its Coordinator)

What can i check for communication in this 2 Xbee ?
answered Mar 18 by vijay.amrutkar New to the Community (2 points)
Contact a Digi expert and get started today! CONTACT US
...