Home  >  Support  >  Support Forum  >  Is it possible to create a mesh network using XB24-Z7WIT-004 moules? If so any suggestions.

Is it possible to create a mesh network using XB24-Z7WIT-004 moules? If so any suggestions.

0 votes
I need to create a mesh network where each node can act as a router
asked Feb 27 in Multipoint Proprietary by xneguvx New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

+1 vote
that shouldn't be hard. You'll need to make sure that your nodes have zigbee router AT or API firmware loaded onto them. You'll also need to have matching pan IDs, sleep, and encryption settings.

you may have a few other lower level challenges. But with the limited information presented, it sounds easily attainable.
answered Feb 27 by kjensen8 Veteran of the Digi Community (509 points)
Contact a Digi expert and get started today! CONTACT US
...