Home  >  Support  >  Support Forum  >  I am using the loopback test described in your web site - timeout
Notice! We've recently migrated to using a new forum, we hope you enjoy it. If you are an existing member and this is your first time visiting our new forum, please reset your password to be able to sign in.

I am using the loopback test described in your web site - timeout

0 votes
I am using the loopback test described in your web site - http://ftp1.digi.com/support/documentation/90001067_a.pdf (2 XBEE PRO S2B) ([1]Sparkfun connected to PC - configured as ZIGBEE COORDINATOR AT <> [2] other platform board configured as out of the box) The Associate pin on [2] blinks after a short bootup, but a loopback test per the reference times out. The ATND command issued from X-CTU initially produced the requisite output but now produces a blank line. Is repeating signal on the "Associate pin" a sign of communication between devices? Thanks
asked Feb 11 in XCTU by Bob Arnold New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Try shorting data in to data out on the remote module. Then set the data receive timeout in the range test to 5 seconds.
answered May 8 by mvut Veteran of the Digi Community (1,552 points)
Contact a Digi expert and get started today! CONTACT US
...