Home  >  Support  >  Support Forum  >  Recovery issue
Notice! We've recently migrated to using a new forum, we hope you enjoy it. If you are an existing member and this is your first time visiting our new forum, please reset your password to be able to sign in.

Recovery issue

0 votes
Hi, I'm following this procedure:

http://www.digi.com/support/kbase/kbaseresultdetl?id=3402#XBee

it works fine but at point 12 when the "action required" pop-ups, pressing the reset button does nothing.

It finds the bootloader, reprograms the firmware but then doesn't find the module anymore.

I've always reduced the COM FIFO settings to the minimums.

Any hints?
asked Oct 15, 2013 in IEEE 802.15.4 by iw2nzm New to the Community (4 points)

Please log in or register to answer this question.

1 Answer

0 votes
- Try the below link and check whether you can see bootloader, http://www.digi.com/support/kbase/kbaseresultdetl?id=3203
If no, contact Digi people, they may repair your XBee module.
- Optimize USB to serial settings using steps in the following link, http://www.digi.com/support/kbase/kbaseresultdetl?id=3418
answered Oct 15, 2013 by 16ksa23 Veteran of the Digi Community (375 points)
Contact a Digi expert and get started today! CONTACT US
...