Home  >  Support  >  Support Forum  >  CM32 Only Recognizes Crossover Cables - Can't Connect to Devices
Notice! We've recently migrated to using a new forum, we hope you enjoy it. If you are an existing member and this is your first time visiting our new forum, please reset your password to be able to sign in.
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

CM32 Only Recognizes Crossover Cables - Can't Connect to Devices

0 votes

My CM32 only recognizes when a device is plugged in when the cable being used is a crossover cable. If a straight through cable is used, the lights on the front of the CM32 don't illuminate.

Even when a crossover cable is used and the light comes on, I cannot connect to an attached device. when I attempt to, it just says "Entering port...", and never goes anywhere.

The firmware is the latest off the Digi website, and I have tried numerous factory resets.

asked Jul 15, 2013 in Console Servers by Ishamael New to the Community (0 points)

Please log in or register to answer this question.

Contact a Digi expert and get started today! CONTACT US