Home  >  Support  >  Support Forum  >  Hello, does one of you already made work the IO line passing on Xbee 900HD?

Hello, does one of you already made work the IO line passing on Xbee 900HD?

0 votes
Hello!

Does one of you already made work the IO line passing function wiyh Xbee 900HD (S3B rev.B). I'M able to get the API frame 0x92 and decode it with an Arduino, But not able to get this information get out on an DIO pin. Any ideas? Thanks a lot,
Raphaël.
asked May 24, 2013 in Multipoint Proprietary by r4ph New to the Community (1 point)

Please log in or register to answer this question.

2 Answers

0 votes
I'm not sure what you are asking, but the 900HD does not support I/O line passing like the older 900Mhz or 802.15.4 firmware. How to tell? Does XCTU offer you a destination MAC address?

Your Arduino can manually forward/repeat the information received. But the newer XBee do not auto-map I/O.
answered May 27, 2013 by lynnl Veteran of the Digi Community (1,043 points)
0 votes
Thanks for your answer. So that was exactly the question, does series 3 support the IO passing line. I finally got that this mode is not supported and used instead the remote AT commands with mac adress to change the state of the do lines.

Thanks anyway for your help,

Raphaël.
answered May 28, 2013 by r4ph New to the Community (1 point)
Contact a Digi expert and get started today! CONTACT US
...